Clogged plugholes are neither fun nor pretty, but they happen to most of us. Slow drainage caused by a partial blockage to your shower or...
How To: Fix A Leaky Toilet
A leaking or dripping toilet is something that most of us will need to deal with at some point. The bad news is that leaking loos are one of the main contributors to water waste. The good news is that, usually, the problem is fairly easy to rectify. Here’s how.
Most of the time, fixing a leaking toilet is as simple as replacing a washer which has deteriorated. The toilet arm is the arm which holds the float; when the float drops because the cistern is empty or low, it opens the inlet valve. As the floating arm rises with the water level, the valve is shut again. If the washer in the valve is damaged, the inlet won’t be completely resealed. This will cause water to leak into the cistern even when the cistern is full; this, in turn, will cause water to flow out through the overflow pipe, resulting in a constant drip or trickling in your toilet.
You will need:
- Replacement washers
- A screwdriver
Step One: Turn off the water
Before you start, you need to turn off your water supply. Turn it off at the stop cock (usually located under the kitchen sink).
Step Two: Drain the tank
Flush the loo to empty the cistern.
Step Three: Access the washer
Remove the split pin that holds the float arm in place. Unscrew the valve cap to reveal the piston that controls the arm. Cistern designs vary, but your damaged washer will be behind the cistern; locate the washer and remove it.
Step Four: Replace and reassemble
Replace the broken washer with a new one, then reassemble the float arm.
Step Five: Test!
Switch the water supply back on and wait for the cistern to fill up. If the drip has gone – well done! If not, you may need to adjust the water level on your cistern; this is fairly easy to do but varies depending on the type of cistern that you have. Basically, you want to raise the floating arm so that it shuts the water off sooner. This can usually be done with a screwdriver by adjusting the screw and nut next to the inlet valve on the floating arm.
Stuck? If you have tried the basics but you still can’t fix the leak, you may need to replace more than a washer. Don’t panic! Call one of our trusted local plumbers who will be able to advise you on what is needed and give you a quote for the job.
Remember, water waste isn’t just bad for the environment; if you are on a meter, it is bad for your bank balance, too, so it is worth fixing the problem as soon as you can.